Same Great Service at All Locations!

Mon - Fri: 7:00 AM - 6:00 PM
Sat: 8:00 AM - 5:00 PM

La Mesa Location

(619) 403-9426

7447 University Ave, La Mesa, CA 91942

Mon - Fri: 7:00 AM - 6:00 PM

Sat & Sun: Closed

Schedule an Appointment

El Cajon Location

(619) 404-5645

10813 Airport Dr., El Cajon, CA 92020

Mon - Fri: 7:00 AM - 6:00 PM

Sat & Sun: Closed

Schedule an Appointment

Articles:

A Clean Start (Battery Cleaning)

You may be fanatical about keeping the outside of your vehicle clean.  But what about what's under the hood? Have you ever thought about how dirt and grime may be affecting your engine's components? One of the most important parts under your hood to keep clean is your vehicle's battery.  With a daily barrage of dirt and moisture, outside parts of your battery can corrode, namely the cables and terminals. Gases vented by batteries can also promote corrosion.  That can create connection problems and affect your vehicle's electrical system.  If corrosion is not cleaned off, it may damage wires and terminals so badly that they will stop properly conducting electricity.  At that point, they may need replacing. When you bring your vehicle to us for a battery inspection and cleaning, we will remove any corrosion and put corrosion-resistant protection on each post. A technician will also visually inspect your battery.  Plus, we can test how much life is in your ba ... read more

Categories:

Battery

Not-So-Common Sense (Sensor Failures)

So your vehicle won't start.  What's the first thing that comes to mind?  Battery dead? Starter motor worn out? Out of gas?  Well, those are all reasons that make sense.  But your vehicle may be refusing to start because one of its computers is being warned that to do so might damage it.  Here's how that works. You have lots of computers in your vehicle.  They need to know the status of things so there are several sensors monitoring various things going on.  These sensors send information to the computers that adjust the fuel and air mixture so you don't waste fuel.  They know when things aren't quite right and prevent you from starting your engine if that's going to damage it.  Other sensors make sure the coolant is the right temperature, check to see you are not polluting the air and make sure other electronic components are performing their tasks correctly. Here's an example of a sensor doing its job.  Your engine needs oil to lubric ... read more

A Honking Big Jam (Stuck Horn)

At one time or another, most drivers honk their horn at someone who might be texting at a stoplight or not paying attention when they're driving.  But what happens when you tap on your horn and all of a sudden it won't quit? Everyone's looking at you like you're an angry jerk and all you want to do is turn it off! It helps to know the basics of what's happening when you honk your horn.  There's a switch in the steering wheel, of course, and when you press on it, it sends power to a relay which then energizes the horn.  Bingo.  Sound.  When the horn sticks on, one of these parts or the wiring has developed a problem.  With the ear-splitting noise inside your cabin, it may be hard to keep your cool, but do your best to stay calm.  Try pushing the horn several times; it may un-stick the switch if you're lucky.  If not, there are a couple of things you can try. First, if you can, pull your vehicle off the road and into a spot where you're not disrupt ... read more

A Clean Sweep (Fuel Injector Cleaning)

Your vehicle gets its power from burning fuel, usually gasoline, and it counts on something called fuel injectors to send gas to the engine in a spray that is easy to ignite.  It’s a precise operation, and when it’s working well, you have plenty of power and an efficient engine. But after time, contaminants in the fuel system may prevent the injectors from spraying like they’re supposed to.  They can also shoot contaminants into the engine.  One sign that could point to dirty fuel injectors is a misfiring engine. Misfires can be caused by several things, so it’s a good idea to bring your vehicle to us so we can trace the cause. Another sign is that your fuel economy has gone downhill or your engine doesn’t have the “pep” it used to. If we discover that your injectors are clogged or not working the way they should, we can clean them to get rid of those contaminants to restore your engine to its top performance.  When you brin ... read more

Categories:

Fuel System

Clean Slate (Protecting Vehicle's Finish)

Winter is one of the hardest times to keep your vehicle clean. But did you know neglecting to wash your vehicle in winter could cost you a significant amount of money in the long run? Here's why. Many areas deal with snow and ice in the winter, and the salt and sand that are used to keep the road surfaces from being slick are also super corrosive to a vehicle's metal body and undercarriage.  That includes all the parts underneath that can be splashed with brine, saltwater and other road debris.  Winter is also tough on vehicles where there isn’t snow, sometimes from ocean salt or winter's extra humidity and rain.  If you have any breaks in your vehicle's paint, whether it be from a little fender bender or a stone chip, that corrosive winter moisture can get through those cracks and start eating away at the metal underneath.  If you can, you should get any dents or damage fixed as soon as possible so your vehicle has a protective layer of paint between road che ... read more

Don't Be Fuelish

If you smell gasoline in your vehicle, pay attention to your nose. That's because it has an important message for you. Newer vehicles should never have a gasoline smell inside. One of the most dangerous conditions can come when your fuel line system has a leak or multiple leaks. Vehicles with fuel injectors are under pressure, meaning a crack or small hole in a fuel line can allow vaporized fuel to escape, sometimes around hot engine parts. Gasoline vapor and hot metal? You see the problem. One of the most common causes of a gasoline smell inside a vehicle is a fuel tank leak. The gas tank can rot or be punctured by road debris. A John's Automotive Care technician can evaluate the condition of your fuel tank and suggest either repair or replacement. Fuel injectors can develop small leaks around their seals or O-rings. Those can deteriorate over time as the material they are made of gets old and less flexible. A technician can replace those parts. Modern vehicles contain something calle ... read more

Categories:

Fuel System

The Red Menace (How to Deal with Rust)

Rust.  It's worse if you drive in places that use salt on the roads in winter, or if you spend time driving near a body of salt water.  But any vehicle has to deal with rust after years on the road.  And it's not just that rust can eat away your vehicle's body and fenders.  It can be a real problem around your suspension, drivetrain or any place where there's metal. Rust takes its time.  You don't see it until it's already done its dirty work.  It can wreak havoc with your electrical system.  Sure, vehicle manufacturers do their best to keep it to a minimum, but especially with road treatments like brine around, their task is a difficult one. The one spot everyone notices is in the paint.  You see a little bubbling under the once-smooth surface.  By the time it bubbles, it's well involved in rotting away that spot of your vehicle.  You wouldn't believe how just a little thing can start the process on its way.  A stone chips the pai ... read more

Getting Off to a Running Start (Starter Replacement)

When you start your vehicle’s engine, there’s another motor that makes that whole process possible.  It’s called the starter, and it’s a small electric motor that gets your vehicle running.   As you can imagine, it’s quite a chore for a little electric motor to turn over the big engine that powers your vehicle.  And after hundreds of successful starting missions, after a while, it will start to give out. You’ll know the starter is starting to give up the ghost when it turns too slowly or sometimes doesn’t do anything when you turn on the ignition.  Maybe it makes funny noises like grinding when you try to start your vehicle or maybe there’s just a click. Those are all reasons to get your vehicle over to us so we can see what’s going on.  A technician will make sure the problem is the starter and not in the battery, a switch, or other electrical component or connections.  If all of those are ruled out, y ... read more

The Vivacious Vernal Vehicle (Preparing Vehicle for Spring)

Most of us look forward to spring because the days are longer, the weather's warmer and we can finally get our vehicles into warm weather mode.  Here are a few things that will breathe fresh energy into anyone's car, SUV, truck or van. First thing is a good cleaning, especially underneath. If you live where salt and brine are used on the roads, it's important to get that off.  One thing to note… if you hose off your undercarriage, be careful not to get your spark plugs/wires wet.  You could notice your vehicle running rough plus the Check Engine light may come on. It usually dries out quickly, but if the engine light stays on for more than a couple of days, have your service facility check it out. Next, replace your windshield wipers.  They've taken a beating through the winter. New ones will have fresh rubber and you'll see clearly (and safely) out your windshield again. Have your brakes inspected.  That salt doesn't do your brake's metal components any ... read more

Categories:

Inspection

In a Fog (Fogged Windows in Cold Weather)

It's bad enough in cold weather when ice and snow block your visibility.  Add to that fog on the inside of your windows and you could be driving blind.  So here are a few tips on how to keep your windows from fogging up when there's a chill in the air. You probably know fog is really condensation, when moist, warm air meets a cold surface and turns to liquid.  If your windshield fogs up, you probably turn on your windshield defroster. Most defrosters blow heated air on the windshield glass to warm it up so it won't condense the moisture.  Many also turn on the air conditioning to reduce the moisture.  That same strategy can work on the rest of the windows.  First, turn up your heater's temperature setting.  The hotter the air, the more moisture it will hold.  Also, turn off the "recirculating" setting since you want all outside air to come in. Then switch on the air conditioning.  It will remove the moisture from the outside  air that i ... read more

John's Automotive Care is committed to ensuring effective communication and digital accessibility to all users. We are continually improving the user experience for everyone, and apply the relevant accessibility standards to achieve these goals. We welcome your feedback. Please call John's Automotive Care (619) 280-9315 if you have any issues in accessing any area of our website.